User's Manual Part 2

Quantum 1000 Base Station User
4.
Debur the center conductor using
5.
Flare the braid slightly and push the connector body onto the cable until the connector snaps into
place, then slide the crimp ring forward
6.
Temporarily slide the crimp ring back, and remove the connector body
excess braid at the crease line, then remount the
it butts up against the
connector body
Quantum 1000 Base Station User
Guide
Rev 1.1, Page
Debur the center conductor using
the DBT-01 deburring tool.
Flare the braid slightly and push the connector body onto the cable until the connector snaps into
place, then slide the crimp ring forward
creasing the braid.
Temporarily slide the crimp ring back, and remove the connector body
from the cable to trim the
excess braid at the crease line, then remount the
connector and slide the crimp ring forward until
connector body
Rev 1.1, Page
67 of 70
Flare the braid slightly and push the connector body onto the cable until the connector snaps into
from the cable to trim the
connector and slide the crimp ring forward until