User's Manual Part 2

Quantum 1000 Base Station User
EZ-400-
NMH Connector
Times Microwave Cable LMR
This installation procedure has been re
1.
Flush cut the cable squarely.
2.
Slide the heat shrink boot and crimp ring onto the
prep/strip tool by inserting the cable into End 1 and rotating the tool. Remove any residual plastic
from the center conductor.
3.
Insert the cable into End 2 of the ST
plastic jacket.
Quantum 1000 Base Station User
Guide
Rev 1.1, Page
NMH Connector
Installation Procedure on
Times Microwave Cable LMR
-400
This installation procedure has been re
-
produced in its entirety from the Times Microwave website.
Flush cut the cable squarely.
Slide the heat shrink boot and crimp ring onto the
cable. Strip the cable end using the ST
prep/strip tool by inserting the cable into End 1 and rotating the tool. Remove any residual plastic
Insert the cable into End 2 of the ST
-400-EZ prep/strip tool and rotate
the tool to remove the
Rev 1.1, Page
66 of 70
produced in its entirety from the Times Microwave website.
cable. Strip the cable end using the ST
-400-EZ
prep/strip tool by inserting the cable into End 1 and rotating the tool. Remove any residual plastic
the tool to remove the