User's Manual Part 2

Quantum 1000 Base Station User
Figure
63
9)
Hit the <ESC> to return to the
“Save” any changes.
10) Select #4 (RADIO
) from the
parameters. It is important that you set all 4 parameters especially the Frequency (this much
match with the CPEs) and the Output Power (figure
• 1 (
Center Frequency (KHz)).
with the CPEs. If the User wishes to change this then please provide the required
frequency is KHz.
• 2 (
Antenna Gain (dB)
• 3 (Cable Loss (dB)
). This is a loss of the cable (in dB’s) from the Base Station to the
Antenna.
• 4 (
Output Power (dBm)
Maximum output power should be set to 36.
Quantum 1000 Base Station User
Guide
Rev 1.1, Page
63
- Base Station CLI Advanced Configuration
Hit the <ESC> to return to the
1.1 BASIC CONFIGURATION
menu. You will be prompted to
) from the
1.1 BASIC CONFIGURATION
menu and assign the
parameters. It is important that you set all 4 parameters especially the Frequency (this much
match with the CPEs) and the Output Power (figure
64).
Center Frequency (KHz)).
This is the frequency of the Base Station and it must match
with the CPEs. If the User wishes to change this then please provide the required
Antenna Gain (dB)
). This is the gain (in dB) for the antenna that is being used.
). This is a loss of the cable (in dB’s) from the Base Station to the
Output Power (dBm)
). This is the output power in dBm. By default it is set at 6.
Maximum output power should be set to 36.
Rev 1.1, Page
56 of 70
menu. You will be prompted to
menu and assign the
following radio
parameters. It is important that you set all 4 parameters especially the Frequency (this much
This is the frequency of the Base Station and it must match
with the CPEs. If the User wishes to change this then please provide the required
). This is the gain (in dB) for the antenna that is being used.
). This is a loss of the cable (in dB’s) from the Base Station to the
). This is the output power in dBm. By default it is set at 6.