Product Manual
Table Of Contents
- 4/5/6 FourStroke
- Welcome
- Read This Manual Thoroughly
- Notice
- Warranty Message
- Copyright and Trademark Information
- Identification Records
- General Information
- Installation
- Transporting
- Fuel and Oil
- Features and Controls
- Operation
- Maintenance
- Outboard Care
- EPA Emission Regulations
- Inspection and Maintenance Schedule
- Flushing the Cooling System
- Top Cowl Removal and Installation
- Corrosion Control Anode
- Exterior Care
- Fuel System
- Propeller Replacement
- Spark Plug Inspection and Replacement
- Lubrication Points
- Changing Engine Oil
- Gearcase Lubrication
- Submerged Outboard
- Storage
- Owner Service Assistance
- Maintenance Log
2. Lubricate the tilt pivot points with lightweight oil.
a - Tilt pivot points
3. Lubricate the following with Extreme Grease or 2‑4‑C with PTFE.
Tube Ref
No.
Description Where Used Part No.
Extreme Grease Propeller shaft 8M0071842
95
2-4-C with PTFE Propeller shaft 92-802859A 1
•
Propeller shaft ‑ refer to Propeller Replacement for removal and
installation of the propeller. Coat the entire propeller shaft with
lubricant to prevent the propeller hub from corroding to the shaft.
27095
Changing Engine Oil
ENGINE OIL CAPACITY
Engine oil capacity is approximately
450 ml (15 fl oz).
OIL CHANGING PROCEDURE
1. Place the outboard in an upright (not tilted) position.
2. Turn the outboard to gain access to the drain plug. Remove the drain plug
and drain the engine oil into an appropriate container. Lubricate the seal
on the drain plug with oil and install.
a
45643
MAINTENANCE
eng 45