Product Manual
Table Of Contents
- 4/5/6 FourStroke
- Welcome
- Read This Manual Thoroughly
- Notice
- Warranty Message
- Copyright and Trademark Information
- Identification Records
- General Information
- Installation
- Transporting
- Fuel and Oil
- Features and Controls
- Operation
- Maintenance
- Outboard Care
- EPA Emission Regulations
- Inspection and Maintenance Schedule
- Flushing the Cooling System
- Top Cowl Removal and Installation
- Corrosion Control Anode
- Exterior Care
- Fuel System
- Propeller Replacement
- Spark Plug Inspection and Replacement
- Lubrication Points
- Changing Engine Oil
- Gearcase Lubrication
- Submerged Outboard
- Storage
- Owner Service Assistance
- Maintenance Log
3. Set the spark plug gap to specification.
26947
Spark Plug
Spark plug gap 0.9 mm (0.035 in.)
4. Before installing spark plug, clean off any dirt on the spark plug seat.
Install plug finger‑tight, and then tighten 1/4 turn or torque to
specifications.
Description Nm lb‑in. lb‑ft
Spark plug 27 – 20
Lubrication Points
1.
Lubricate the following with 2‑4‑C with PTFE or Extreme Grease.
Tube Ref
No.
Description Where Used Part No.
95
2-4-C with PTFE
Co-pilot, swivel bracket, transom clamp
screws, tiller handle bushing, shift
handle detent
92-802859A 1
Extreme Grease
Co-pilot, swivel bracket, transom clamp
screws, tiller handle bushing, shift
handle detent
8M0071842
• Co‑pilot ‑ lubricate threads.
•
Swivel bracket ‑ lubricate through fittings.
a - Swivel bracket lubrication fittings
b - Co‑pilot
a
b
45640
MAINTENANCE
eng 43