Product Manual
Table Of Contents
- 4/5/6 FourStroke
- Welcome
- Read This Manual Thoroughly
- Notice
- Warranty Message
- Copyright and Trademark Information
- Identification Records
- General Information
- Installation
- Transporting
- Fuel and Oil
- Features and Controls
- Operation
- Maintenance
- Outboard Care
- EPA Emission Regulations
- Inspection and Maintenance Schedule
- Flushing the Cooling System
- Top Cowl Removal and Installation
- Corrosion Control Anode
- Exterior Care
- Fuel System
- Propeller Replacement
- Spark Plug Inspection and Replacement
- Lubrication Points
- Changing Engine Oil
- Gearcase Lubrication
- Submerged Outboard
- Storage
- Owner Service Assistance
- Maintenance Log
• Warm engine ‑ Move to the RE‑START position.
a - Warm engine start
b - Cold engine start
8. If engine is cold, completely pull out the choke. Push in the choke halfway
as the engine is warming up. Push in completely after engine is warmed
up.
a - Choke
NOTE: Starting flooded engine ‑ Push in the choke knob. Wait 30 seconds,
then continue to crank engine for starting.
9. Pull the starter rope slowly until you feel the starter engage, then pull
rapidly to crank the engine. Allow rope to return slowly. Repeat until
engine starts.
a - Starter rope
10. Check for a steady stream of water flowing out of the water pump
indicator hole.
START
RE-START
a
b
45624
a
45625
a
45626
OPERATION
30 eng