Product Manual
Table Of Contents
- 4/5/6 FourStroke
- Welcome
- Read This Manual Thoroughly
- Notice
- Warranty Message
- Copyright and Trademark Information
- Identification Records
- General Information
- Installation
- Transporting
- Fuel and Oil
- Features and Controls
- Operation
- Maintenance
- Outboard Care
- EPA Emission Regulations
- Inspection and Maintenance Schedule
- Flushing the Cooling System
- Top Cowl Removal and Installation
- Corrosion Control Anode
- Exterior Care
- Fuel System
- Propeller Replacement
- Spark Plug Inspection and Replacement
- Lubrication Points
- Changing Engine Oil
- Gearcase Lubrication
- Submerged Outboard
- Storage
- Owner Service Assistance
- Maintenance Log
Installing Outboard
BOAT TRANSOM HEIGHT REQUIREMENT
Measure the transom height of your boat. The anti‑ventilation plate should be
25–50 mm (1–2 in.)
below the bottom of the boat.
a - Anti‑ventilation plate
INSTALLING OUTBOARD ON TRANSOM
1.
Place the outboard on the centerline of the transom.
27005
2. Tighten the transom clamp handles.
45603
a
27004
INSTALLATION
12 eng