Product Manual
Table Of Contents
- 5 HP FourStroke Propane
- Welcome
- Read This Manual Thoroughly
- Notice
- Safety and Regulatory Notices
- Warranty Message
- Copyright and Trademark Information
- Identification Records
- General Information
- Installation
- Transporting
- Fuel and Oil
- Features and Controls
- Operation
- Maintenance
- Outboard Care
- EPA Emissions Regulations
- Inspection and Maintenance Schedule
- Flushing the Cooling System
- Top Cowl Removal and Installation
- Corrosion Control Anode
- Exterior Care
- Fuel System
- Propeller Replacement
- Spark Plug Inspection and Replacement
- Lubrication Points
- Changing Engine Oil
- Gearcase Lubrication
- Submerged Outboard
- Storage
- Owner Service Assistance
- Maintenance Log
Use a Mercury Precision or Quicksilver accessory (or equivalent) flushing
attachment.
NOTE: Do not run the engine while flushing the cooling system.
1. Remove the plug and gasket.
2. Install the hose coupling into the plug opening.
3. Attach a water hose to the hose coupling. Turn on the water gently and
flush the cooling system for 3–5 minutes.
4. Remove the hose coupling and install the plug and gasket.
a - Plug and gasket
b - Hose coupling
Top Cowl Removal and Installation
REMOVAL
1.
Release the rear latch.
2. Lift up the rear of the cowl and push it towards the front of the engine to
clear the front hook.
68562
INSTALLATION
1.
Engage the front hook and position the cowl over the engine.
2. Lock the rear latch.
a
68632
b
MAINTENANCE
34 eng