Product Manual
Table Of Contents
- 8/9.9 and 9.9 Command Thrust/ProKicker FourStroke
- Welcome
- Read This Manual Thoroughly
- Notice
- Warranty Message
- Copyright and Trademark Information
- Identification Records
- General Information
- Boater's Responsibilities
- Before Operating Your Outboard
- Boat Horsepower Capacity
- High-Speed and High-Performance Boat Operation
- Outboard Remote Control Models
- Remote Steering Notice
- Lanyard Stop Switch
- Protecting People in the Water
- Passenger Safety Message - Pontoon Boats and Deck Boats
- Wave and Wake Jumping
- Impact with Underwater Hazards
- Exhaust Emissions
- Selecting Accessories for Your Outboard
- Safe Boating Recommendations
- Recording Serial Number
- 8/9.9 FourStroke Specifications
- Component Identification - Standard Models
- Component Identification - Command Thrust/ProKicker Models
- Transporting
- Fuel and Oil
- Features and Controls
- Operation
- Prestarting Check List
- Operating in Freezing Temperatures
- Operating in Saltwater or Polluted Water
- Operating Outboard as an Auxiliary Engine
- Prestarting Instructions
- Engine Break-in Procedure
- Starting the Engine - Tiller Handle Models
- Starting the Engine - Remote Control Models
- Starting a Hot Engine
- Gear Shifting
- Stopping the Engine
- Emergency Starting
- Maintenance
- Outboard Care
- EPA Emission Regulations
- Inspection and Maintenance Schedule
- Flushing the Cooling System
- Top Cowl Removal And Installation
- Battery Inspection
- Exterior Care
- Fuel System
- Steering Link Rod Fasteners
- Corrosion Control Anode
- Propeller Replacement
- Fuse Replacement - Electric Start Models
- Spark Plug Inspection and Replacement
- Timing Belt Inspection
- Changing Engine Oil
- Lubrication Points
- Gearcase Lubrication
- Checking Power Tilt Fluid
- Submerged Outboard
- Storage
- Troubleshooting
- Owner Service Assistance
- Installation
- Boat Horsepower Capacity
- Start in Gear Protection
- Selecting Accessories for Your Outboard
- Low Permeation Fuel Hose Requirement
- Mercury Marine Validated Engine Mounting Hardware
- Installing Outboard
- Remote Control Installation
- Steering Link Rod Fasteners
- Remote Wire Harness Connection
- Control Cable Installation
- Battery Installation - Electric Start Models
- Battery Connections
- Propeller Installation
- Maintenance Log
- General Information
• Touch up any paint nicks. See your dealer for touch‑up paint.
•
Spray Quicksilver or Mercury Precision Lubricants Corrosion Guard on
external metal surfaces (except corrosion control anodes).
Tube Ref
No.
Description Where Used Part No.
120
Corrosion Guard External metal surfaces 92-802878 55
Protecting Internal Engine Components
•
Remove the spark plugs and add approximately 30 ml (1 oz.) of engine oil
or inject a five second spray of storage seal inside of each cylinder.
• Rotate the flywheel manually several times to distribute the oil in the
cylinders. Install spark plugs.
• Change the engine oil.
Gearcase
•
Drain and refill the gearcase lubricant (refer to Gearcase Lubrication).
Positioning Outboard for Storage
NOTICE
Storing the outboard in a tilted position can damage the outboard. Water
trapped in the cooling passages or rain water collected in the propeller
exhaust outlet in the gearcase can freeze. Store the outboard in the full down
position.
• To prevent problems which can be caused by oil entering the cylinders
from the sump, only store the outboard in one of the three positions
shown.
a - Upright position
b - Tiller handle down
c - Front side down
a
b
c
39056
37-892904-010
THIS SIDE UP
NOTICE
STORAGE
78 eng