Product Manual

6. Turn the ignition key to the START position. If the engine is cold, push the
key in to choke the engine while cranking. If the engine fails to start in ten
seconds, wait 30 seconds and try again. If the engine begins to stall, push
the key in (choke) until the engine is running smoothly.
19804
7. Check for a steady stream of water flowing out of the water pump
indicator hole.
27240
IMPORTANT: If no water is coming out of the water pump indicator hole, stop
the engine and check the cooling water intake for obstruction. No obstruction
may indicate a water pump failure or blockage in the cooling system. These
conditions will cause the engine to overheat. Have the outboard checked by
your dealer. Operating the engine while overheated will cause engine damage.
WARMING UP ENGINE
Before beginning operation, allow the engine to warm up at idling speed for
three minutes.
Starting a Hot Engine
TILLER HANDLE MODELS
1.
Pull the choke knob out one detent. The choke is partially open.
2. Crank the engine with the recoil rope or with the electric start button.
3. Push the choke knob in after the engine has started.
REMOTE CONTROL MODELS
1. Crank the engine over while pushing the key in to engage the choke
solenoid.
2. After the engine has started, release the key.
Gear Shifting
IMPORTANT: Never shift outboard into gear unless engine speed is at idle. Do
not shift outboard into reverse when the engine is not running.
OPERATION
52 eng