Product Manual
Table Of Contents
- 8/9.9 and 9.9 Command Thrust/ProKicker FourStroke
- Welcome
- Read This Manual Thoroughly
- Notice
- Warranty Message
- Copyright and Trademark Information
- Identification Records
- General Information
- Boater's Responsibilities
- Before Operating Your Outboard
- Boat Horsepower Capacity
- High-Speed and High-Performance Boat Operation
- Outboard Remote Control Models
- Remote Steering Notice
- Lanyard Stop Switch
- Protecting People in the Water
- Passenger Safety Message - Pontoon Boats and Deck Boats
- Wave and Wake Jumping
- Impact with Underwater Hazards
- Exhaust Emissions
- Selecting Accessories for Your Outboard
- Safe Boating Recommendations
- Recording Serial Number
- 8/9.9 FourStroke Specifications
- Component Identification - Standard Models
- Component Identification - Command Thrust/ProKicker Models
- Transporting
- Fuel and Oil
- Features and Controls
- Operation
- Prestarting Check List
- Operating in Freezing Temperatures
- Operating in Saltwater or Polluted Water
- Operating Outboard as an Auxiliary Engine
- Prestarting Instructions
- Engine Break-in Procedure
- Starting the Engine - Tiller Handle Models
- Starting the Engine - Remote Control Models
- Starting a Hot Engine
- Gear Shifting
- Stopping the Engine
- Emergency Starting
- Maintenance
- Outboard Care
- EPA Emission Regulations
- Inspection and Maintenance Schedule
- Flushing the Cooling System
- Top Cowl Removal And Installation
- Battery Inspection
- Exterior Care
- Fuel System
- Steering Link Rod Fasteners
- Corrosion Control Anode
- Propeller Replacement
- Fuse Replacement - Electric Start Models
- Spark Plug Inspection and Replacement
- Timing Belt Inspection
- Changing Engine Oil
- Lubrication Points
- Gearcase Lubrication
- Checking Power Tilt Fluid
- Submerged Outboard
- Storage
- Troubleshooting
- Owner Service Assistance
- Installation
- Boat Horsepower Capacity
- Start in Gear Protection
- Selecting Accessories for Your Outboard
- Low Permeation Fuel Hose Requirement
- Mercury Marine Validated Engine Mounting Hardware
- Installing Outboard
- Remote Control Installation
- Steering Link Rod Fasteners
- Remote Wire Harness Connection
- Control Cable Installation
- Battery Installation - Electric Start Models
- Battery Connections
- Propeller Installation
- Maintenance Log
- General Information
3.
Set the lanyard stop switch to RUN position. Refer to General
Information—Lanyard Stop Switch.
19791
4. Set the tiller handle gear shift to the neutral start position.
57677
5.
Cold engine ‑
•
Pull the choke knob out two detent positions for starting a cold engine.
The choke is closed in this position.
• After the engine is running, push the choke knob in one detent. The
choke is partially open in this position.
• After the engine starts to warm up, push the choke knob in. The choke
is open in this position.
a - Choke is open
b - Choke is partially open
c - Choke is closed
IMPORTANT: Outboards with battery charging capabilities must not be
operated with battery cables disconnected from the battery. Damage to the
charging system may result.
a
b
c
57690
OPERATION
48 eng