Product Manual

Tube Ref No. Description Where Used Part No.
95
2-4-C with PTFE Friction plate 92-802859A 1
b. Insert the friction plate spring through the wire loop.
c.
Align the tabs on the recoil housing with the holes on the friction plate.
d. Apply Loctite® 271 Threadlocker to the threads of the friction plate retaining screw. Tighten the friction plate retaining
screw to the specified torque.
a - Starter pawl
b - Friction plate retaining screw
c - Friction plate spring
d - Wire loop
Description Nm lb‑in. lb‑ft
Friction plate retaining screw 6.0 53.1 –
Tube Ref No. Description Where Used Part No.
7
Loctite® 271
Threadlocker
Threads of the friction plate retaining screw 92-809819
8. Complete the rope installation:
a.
Insert the recoil rope into the guide and through the recoil housing.
b. Insert the rope end through the recoil handle.
c. Tie a knot as shown. Place the rope knot into the handle cap, and insert the cap into the recoil handle.
9748
d. Insert the recoil rope into the notch on the sheave.
e.
Wind the sheave three turns counterclockwise to preload the recoil spring.
a - Recoil rope
b - Sheave notch
c - Recoil rope guide
d - Recoil housing opening
f. Allow the recoil rope to retract into the sheave.
g.
Ensure the recoil rope retracts and extends fully.
a
b
c
d
9741
a
b
c
d
63304
Recoil Starter
Page 8A-10 © 2018 Mercury Marine 90-8M0125265 eng NOVEMBER 2017