Product Manual

4. Insert the anchor of the bottom cable into the lower slot in the throttle drum. Insert the anchor of the top cable into the
upper slot in the throttle drum. Coat both anchors with 2‑4‑C with PTFE.
Tube Ref No. Description Where Used Part No.
95
2-4-C with PTFE Throttle cable anchors 92-802859A 1
5. Rotate the throttle grip to the idle position.
6.
Slide the throttle cables into the slots on the throttle bracket. Temporarily secure the cables so as to allow throttle grip
rotation.
7. Rotate the throttle grip to WOT. The throttle drum should contact the throttle drum WOT stop.
• If the throttle operates properly, tighten the lower throttle cable jam nuts to secure the lower cable.
• If the drum does not contact the WOT stop, adjust the lower cable jam nuts until proper contact is made.
8. Return the throttle grip to idle.
a. Ensure that the throttle drum rests on the idle stop.
b. Tighten the upper throttle cable jam nuts to minimize slack in the upper cable.
a - Throttle drum WOT stop
b - Throttle drum
c - Throttle cable ends
d - Throttle link
e - Throttle drum idle stop
f - Bracket throttle stop
g - Lower throttle cable jam nuts
h - Upper throttle cable jam nuts
Throttle Cable Adjustments
1.
Rotate the tiller twist grip to the idle position.
2. Adjust the cable lengths by using the jam nuts to bring the idle stop on the throttle drum against the throttle stop.
a. Make adjustments to the lower cable first.
b. Remove slack in the upper cable by adjusting the upper jam nuts. Do not overtighten.
63154
b
c
d
e
f
g
h
a
Tiller Handle
Page 7B-22 © 2018 Mercury Marine 90-8M0125265 eng NOVEMBER 2017