Product Manual

3. Remove the brush holder and brush.
a - Blue wire
b - Green wire
c - Screw
d - Brush holder
e - Brush
f - Spring
g - Breaker
h - Motor bracket
i - O‑ring
Power Tilt Motor Reassembly
1.
Install the breaker into the motor bracket.
2. Install the breaker holder and secure with a screw.
3. Attach the blue wire to the terminal post of the breaker.
4. Route the green wire along the inside diameter of the bracket.
5. Install the brush holder and secure with a screw.
6. Attach the green wire and brush wire terminal to the motor bracket. Secure with a screw.
7. Install two springs into the brush and breaker slots under the holders.
8. Install the breaker and the brush into the slots.
a - Blue wire
b - Green wire
c - Screw
d - Brush holder
e - Brush
f - Spring
g - Breaker
h - Motor bracket
i - O‑ring
9. Hold the brushes in the slots while installing the armature into the motor bracket.
8425
a
b
d
e
e
d
c
c
c
h
i
f
f
g
8425
a
b
d
e
e
d
c
c
c
h
i
f
f
g
Power Tilt
90-8M0125265 eng NOVEMBER 2017 © 2018 Mercury Marine Page 5B-23