Product Manual

7. Install the screw and washer that secure the upper pivot pin. Tighten the screw to the specified torque.
a - Screw and washer
b - Upper pivot pin
c - Lower pivot pin screw and washer
d - Power tilt unit
Description Nm lb‑in. lb‑ft
Lower pivot pin screw (M8 x 20) 13 115 –
Upper pivot pin screw (M6 x 12) 6.0 53.1 –
8. Route the power tilt pump wires through the port clamp bracket.
9. Secure the power tilt pump wires to the inside of the clamp bracket with two cable ties.
10. Secure the power tilt pump wires to the outside of the clamp bracket with a P‑clip and screw.
11. Attach the ground cable to the power tilt unit. Tighten the screw to the specified torque.
12. Lubricate the tilt tube with 2‑4‑C with PTFE through the grease fittings on the swivel bracket.
a - P‑clip
b - Hole through the port clamp bracket
c - Cable ties (two)
d - Ground cable screw
e - Grease fittings (two)
Tube Ref No. Description Where Used Part No.
95
2-4-C with PTFE Tilt tube 92-802859A 1
Description Nm lb‑in. lb‑ft
Ground cable screw (M6 x 12) 6.0 53.1 –
Steering Arm Installation
1.
Install a washer onto the steering arm shaft.
2. Insert the steering arm into the swivel bracket. Ensure that the lower bushing remains in the swivel bracket.
3. For tiller handle models:
35122
a
b
c
d
a
c
d
e
63660
b
Clamp/Swivel Bracket and Driveshaft Housing
90-8M0125265 eng NOVEMBER 2017 © 2018 Mercury Marine Page 5A-35