Product Manual

6. Align the lower pivot pin with the port clamp bracket bushing and push the clamp bracket onto the lower pivot pin.
a - Lower pivot pin
b - Clamp bracket bushing
7. Install the lower pivot pin screw and washer. Tighten the screw to the specified torque.
8. Lubricate the plastic washer on the tilt tube with 2‑4‑C with PTFE.
9. Install the tilt tube locknut. Tighten the locknut to the specified torque.
10. Install the cap.
a - Cap
b - Locknut
c - P‑clip
d - Cable ties (2)
e - Tilt lock pin, locknut, and washer
f - Lower pivot pin screw (M8 x 20) and washer
g - Ground cable screw on power tilt unit
h - Port clamp bracket
Tube Ref No. Description Where Used Part No.
95
2-4-C with PTFE Tilt tube washer 92-802859A 1
Description Nm lb‑in. lb‑ft
Lower pivot pin screw (M8 x 20) 13 115 –
Tilt tube locknut 24.0 – 17.7
11. Route the power tilt pump wires through the grommet in the port driveshaft housing cover. Ensure that the grommet is
properly seated in the cover.
35067
a
b
a
b
c
d
e
d
f
g
h
63659
Clamp/Swivel Bracket and Driveshaft Housing
90-8M0125265 eng NOVEMBER 2017 © 2018 Mercury Marine Page 5A-27