Product Manual

16. Install two starter assembly screws. Tighten the screws to the specified torque.
10502
Description Nm lb‑in. lb‑ft
Starter assembly screw 6.0 53.1 –
17. Lubricate the armature shaft and helix with SAE Engine Oil 30W.
10541
Tube Ref No. Description Where Used Part No.
80
SAE® Engine Oil 30W Starter armature shaft, and helix Obtain Locally
18. Install the starter bendix, bendix spring, and pinion stopper. Secure the starter bendix assembly with a circlip. Push the
pinion stopper up to capture the circlip.
a - Bendix
b - Bendix spring
c - Pinion stopper
d - Circlip
Starter Motor Installation
1.
Ensure that the rubber isolator is around the body of the starter motor. Position the isolator bracket over the isolator, and
move the starter motor and isolator bracket into place.
2. Attach the starter motor to the engine with two mounting screws. Tighten the screws to the specified torque.
Description Nm lb‑in. lb‑ft
Starter motor mounting screws (2) 13 115 –
3. Attach the isolator bracket to the engine with two screws. Tighten the screws to the specified torque.
Description Nm lb‑in. lb‑ft
Starter motor isolator bracket screws 6.0 53.1 –
4. Connect any connectors and install any components removed to access the port side isolator bracket screw.
5.
Attach the positive cable to the starter motor, using a lockwasher and nut. Tighten the nut to the specified torque.
6. Attach the negative cable to the starter motor, using a lockwasher and nut. Tighten the nut to the specified torque.
d
c
b
a
22261
Charging and Starting Systems
Page 2B-18 © 2018 Mercury Marine 90-8M0125265 eng NOVEMBER 2017