Product Manual
Table Of Contents
- 8/9.9 and 9.9 Command Thrust/ProKicker FourStroke
- Welcome
- Read This Manual Thoroughly
- Notice
- Warranty Message
- Copyright and Trademark Information
- Identification Records
- General Information
- Boater's Responsibilities
- High-Speed and High-Performance Boat Operation
- Outboard Remote Control Models
- Remote Steering Notice
- Lanyard Stop Switch
- Protecting People in the Water
- Passenger Safety Message - Pontoon Boats and Deck Boats
- Wave and Wake Jumping
- Impact with Underwater Hazards
- Exhaust Emissions
- Safe Boating Recommendations
- Recording Serial Number
- Model Year Production Code
- 8/9.9 FourStroke Specifications
- Component Identification - Standard Models
- Component Identification - Command Thrust/ProKicker Models
- Installation
- Boat Horsepower Capacity
- Start in Gear Protection
- Selecting Accessories for Your Outboard
- Low Permeation Fuel Hose Requirement
- Mercury Marine Validated Engine Mounting Hardware
- Installing Outboard
- Remote Control Installation
- Steering Link Rod Fasteners
- Remote Wire Harness Connection
- Control Cable Installation
- Battery Installation - Electric Start Models
- Battery Connections
- Propeller Installation
- Transporting
- Fuel and Oil
- Features and Controls
- Operation
- Prestarting Check List
- Operating in Freezing Temperatures
- Operating in Saltwater or Polluted Water
- Operating Outboard as an Auxiliary Engine
- Prestarting Instructions
- Engine Break-in Procedure
- Starting the Engine - Tiller Handle Models
- Starting the Engine - Remote Control Models
- Starting a Hot Engine
- Gear Shifting
- Stopping the Engine
- Emergency Starting
- Maintenance
- Cleaning Care Recommendations
- EPA Emission Regulations
- Inspection and Maintenance Schedule
- Maintenance Schedule Decal Icons
- Maintenance Schedule Decal
- Flushing the Cooling System
- Top Cowl Removal and Installation
- Battery Inspection
- Exterior Care
- Fuel System
- Steering Link Rod Fasteners
- Corrosion Control Anode
- Propeller Replacement
- Fuse Replacement - Electric Start Models
- Spark Plug Inspection and Replacement
- Timing Belt Inspection
- Changing Engine Oil
- Lubrication Points
- Gearcase Lubrication
- Checking Power Tilt Fluid
- Submerged Outboard
- Storage
- Troubleshooting
- Owner Service Assistance
- Maintenance Log
- General Information
Description Nm lb‑in. lb‑ft
Cable receptacle bracket 6 53 –
Control Cable Installation
THROTTLE CABLE INSTALLATION
Install the cables into the remote control following the instructions provided with
the remote control.
1. Position the remote control handle into full forward throttle position.
NOTE: The throttle cable is the second cable to move when moving the
control box out of neutral.
2. Attach the throttle cable end guide to the throttle lever with a washer and
cotter pin retainer.
3. Adjust the cable barrel so that the installed throttle cable will hold the
throttle level against the throttle stop.
4. Position the throttle cable into the rubber grommet and place the cable
barrel into the barrel receptacle.
5. Move the remote control handle to the full throttle position and check to
make sure that the throttle cable end guide does not contact the remote
control harness.
INSTALLATION
30 eng