Product Manual
Table Of Contents
- 8/9.9 and 9.9 Command Thrust/ProKicker FourStroke
- Welcome
- Read This Manual Thoroughly
- Notice
- Warranty Message
- Copyright and Trademark Information
- Identification Records
- General Information
- Boater's Responsibilities
- High-Speed and High-Performance Boat Operation
- Outboard Remote Control Models
- Remote Steering Notice
- Lanyard Stop Switch
- Protecting People in the Water
- Passenger Safety Message - Pontoon Boats and Deck Boats
- Wave and Wake Jumping
- Impact with Underwater Hazards
- Exhaust Emissions
- Safe Boating Recommendations
- Recording Serial Number
- Model Year Production Code
- 8/9.9 FourStroke Specifications
- Component Identification - Standard Models
- Component Identification - Command Thrust/ProKicker Models
- Installation
- Boat Horsepower Capacity
- Start in Gear Protection
- Selecting Accessories for Your Outboard
- Low Permeation Fuel Hose Requirement
- Mercury Marine Validated Engine Mounting Hardware
- Installing Outboard
- Remote Control Installation
- Steering Link Rod Fasteners
- Remote Wire Harness Connection
- Control Cable Installation
- Battery Installation - Electric Start Models
- Battery Connections
- Propeller Installation
- Transporting
- Fuel and Oil
- Features and Controls
- Operation
- Prestarting Check List
- Operating in Freezing Temperatures
- Operating in Saltwater or Polluted Water
- Operating Outboard as an Auxiliary Engine
- Prestarting Instructions
- Engine Break-in Procedure
- Starting the Engine - Tiller Handle Models
- Starting the Engine - Remote Control Models
- Starting a Hot Engine
- Gear Shifting
- Stopping the Engine
- Emergency Starting
- Maintenance
- Cleaning Care Recommendations
- EPA Emission Regulations
- Inspection and Maintenance Schedule
- Maintenance Schedule Decal Icons
- Maintenance Schedule Decal
- Flushing the Cooling System
- Top Cowl Removal and Installation
- Battery Inspection
- Exterior Care
- Fuel System
- Steering Link Rod Fasteners
- Corrosion Control Anode
- Propeller Replacement
- Fuse Replacement - Electric Start Models
- Spark Plug Inspection and Replacement
- Timing Belt Inspection
- Changing Engine Oil
- Lubrication Points
- Gearcase Lubrication
- Checking Power Tilt Fluid
- Submerged Outboard
- Storage
- Troubleshooting
- Owner Service Assistance
- Maintenance Log
- General Information
Service Assistance
LOCAL REPAIR SERVICE
If you need service for your Mercury‑outboard‑powered boat, take it to your
authorized dealer. Only authorized dealers specialize in Mercury products and
have factory‑trained mechanics, special tools and equipment, and genuine
Quicksilver parts and accessories to properly service your engine.
NOTE: Quicksilver parts and accessories are engineered and built by Mercury
Marine specifically for your power package.
SERVICE AWAY FROM HOME
If you are away from your local dealer and the need arises for service, contact
the nearest authorized dealer. If, for any reason, you cannot obtain service,
contact the nearest Regional Service Center. Outside the United States and
Canada, contact the nearest Marine Power International Service Center.
STOLEN POWER PACKAGE
If your power package is stolen, immediately advise the local authorities and
Mercury Marine of the model and serial numbers and to whom the recovery is
to be reported. This information is maintained in a database at Mercury Marine
to aid authorities and dealers in the recovery of stolen power packages.
ATTENTION REQUIRED AFTER SUBMERSION
1. Before recovery, contact an authorized Mercury dealer.
2. After recovery, immediate service by an authorized Mercury dealer is
required to reduce the possibility of serious engine damage.
REPLACEMENT SERVICE PARTS
!
WARNING
Avoid fire or explosion hazard. Electrical, ignition, and fuel system
components on Mercury Marine products comply with federal and
international standards to minimize risk of fire or explosion. Do not use
replacement electrical or fuel system components that do not comply with
these standards. When servicing the electrical and fuel systems, properly
install and tighten all components.
Marine engines are expected to operate at or near full throttle for most of their
lives. They are also expected to operate in both fresh and saltwater
environments. These conditions require numerous special parts.
PARTS AND ACCESSORIES INQUIRIES
Direct any inquiries concerning genuine Mercury Precision Parts® or
Quicksilver Marine Parts and Accessories® to a local authorized dealer.
Dealers have the proper systems to order parts and accessories, if they are not
in stock. Engine model and serial number are required to order correct parts.
OWNER SERVICE ASSISTANCE
eng 101