Product Manual
Table Of Contents
- 8/9.9 and 9.9 Command Thrust/ProKicker FourStroke
- Welcome
- Read This Manual Thoroughly
- Notice
- Warranty Message
- Copyright and Trademark Information
- Identification Records
- General Information
- Boater's Responsibilities
- High-Speed and High-Performance Boat Operation
- Outboard Remote Control Models
- Remote Steering Notice
- Lanyard Stop Switch
- Protecting People in the Water
- Passenger Safety Message - Pontoon Boats and Deck Boats
- Wave and Wake Jumping
- Impact with Underwater Hazards
- Exhaust Emissions
- Safe Boating Recommendations
- Recording Serial Number
- Model Year Production Code
- 8/9.9 FourStroke Specifications
- Component Identification - Standard Models
- Component Identification - Command Thrust/ProKicker Models
- Installation
- Boat Horsepower Capacity
- Start in Gear Protection
- Selecting Accessories for Your Outboard
- Low Permeation Fuel Hose Requirement
- Mercury Marine Validated Engine Mounting Hardware
- Installing Outboard
- Remote Control Installation
- Steering Link Rod Fasteners
- Remote Wire Harness Connection
- Control Cable Installation
- Battery Installation - Electric Start Models
- Battery Connections
- Propeller Installation
- Transporting
- Fuel and Oil
- Features and Controls
- Operation
- Prestarting Check List
- Operating in Freezing Temperatures
- Operating in Saltwater or Polluted Water
- Operating Outboard as an Auxiliary Engine
- Prestarting Instructions
- Engine Break-in Procedure
- Starting the Engine - Tiller Handle Models
- Starting the Engine - Remote Control Models
- Starting a Hot Engine
- Gear Shifting
- Stopping the Engine
- Emergency Starting
- Maintenance
- Cleaning Care Recommendations
- EPA Emission Regulations
- Inspection and Maintenance Schedule
- Maintenance Schedule Decal Icons
- Maintenance Schedule Decal
- Flushing the Cooling System
- Top Cowl Removal and Installation
- Battery Inspection
- Exterior Care
- Fuel System
- Steering Link Rod Fasteners
- Corrosion Control Anode
- Propeller Replacement
- Fuse Replacement - Electric Start Models
- Spark Plug Inspection and Replacement
- Timing Belt Inspection
- Changing Engine Oil
- Lubrication Points
- Gearcase Lubrication
- Checking Power Tilt Fluid
- Submerged Outboard
- Storage
- Troubleshooting
- Owner Service Assistance
- Maintenance Log
- General Information
Tools necessary for minor repairs
Anchor and extra anchor line
Manual bilge pump and extra drain plugs
Drinking water
Radio
Paddle or oar
Spare propeller, thrust hubs, and an appropriate wrench
First aid kit and instructions
Waterproof storage containers
Spare operating equipment, batteries, bulbs, and fuses
Compass and map or chart of the area
Personal flotation device (one per person onboard)
Watch for signs of weather change and avoid foul weather and rough‑sea
boating.
Tell someone where you are going and when you expect to return.
Passenger boarding.
• Stop the engine whenever passengers are boarding, unloading, or are
near the back (stern) of the boat. Shifting the drive unit into neutral is not
sufficient.
Use personal flotation devices.
• Federal law requires that there be a U.S. Coast Guard‑approved life
jacket (personal flotation device), correctly sized and readily accessible
for every person onboard, plus a throwable cushion or ring. We strongly
advise that everyone wear a life jacket at all times while in the boat.
Prepare other boat operators.
• Instruct at least one person onboard in the basics of starting and
operating the engine and boat handling in case the driver becomes
disabled or falls overboard.
Do not overload your boat.
• Most boats are rated and certified for maximum load (weight) capacities
(refer to your boat's capacity plate). Know your boat's operating and
loading limitations. Know if your boat will float if it is full of water. When in
doubt, contact your authorized Mercury Marine dealer or the boat
manufacturer.
Ensure that everyone in the boat is properly seated.
GENERAL INFORMATION
12 eng