Instruction Manual

M
USB Cable
Wireless Remote
TEN Pads
Power
Button
Charging Port
CR2032
CONTENTS
• TENS Neck Massager
• Wireless Remote
FEATURES
• TENS massage with heat mode
• 3 massage modes and 15 strength levels
• Wireless remote with magnetic mounting
GETTING STARTED
Increase Intensity
Massage
Modes
Heat Off Heat On
Decrease
Intensity
M
Warning: Use massager only as indicated. Do not use
massager for any other body areas.
1. Charge using the provided USB cable and unplug
when fully charged.
2. Secure the rubber charging port cover.
3. Remove any electronic items or jewelry you are wearing.
4. Using a clean, damp towel, moisten the sides and
back of your neck.
5. Place the massager around your neck. Make sure
the TENS pads are in full contact with your skin.
6. Turn on the massager by pressing the power button.
A tone will be heard when massager is turns on.
7. Find your comfort level. Press the [+] button to
increase massage intensity and the [-] button to
decrease massage intensity.
Note: Massager will turn off if left at the lowest
setting.
8. Press the [M] button to toggle through the 3
massage modes.
Note: changing modes resets massage intensity to
lowest level.
9. Press the button to turn heat on and press the
button to turn heat off.
10. Press and hold the [-] button turn off sound cues.
Press and hold the [+] button to turn on sound cues.
11. Use for up to 15 minutes at a time but no more than
30 minutes per day.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
Note: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications. However,
this is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician
for help.
Caution: Any changes or modifications to this unit not
expressly approved by the party responsible for
compliance could void the user’s authority to operate the
equipment.
FCC STATEMENT