Operation Manual

X
Turn the SmartKey to position 1 or 2 in the
ignition lock.
X
Press the 3 switch in direction :.
Both roller sunblinds open, then the pano-
rama roof with power tilt/sliding panel is
raised.
X
Pull the 3 switch in direction ;.
The sunblinds open.
X
Pull the 3 switch in direction =.
The roller sunblinds close when the panorama
roof with power tilt/sliding panel is closed.
If you press or pull the 3 switch beyond the
point of resistance, automatic operation is star-
ted in the corresponding direction. You can stop
automatic operation by pressing or pulling
again.
Resetting the panorama roof with
power tilt/sliding panel or the front
roller sunblind
!
If the panorama roof with power tilt/sliding
panel and the roller sunblinds cannot be fully
opened or closed after resetting, contact a
qualified specialist workshop.
Reset the panorama roof with power tilt/sliding
panel or the roller sunblinds if the panorama
roof with power tilt/sliding panel or the front
roller sunblind does not move smoothly.
X
Turn the SmartKey to position 1 or 2 in the
ignition lock.
X
Pull the 3 switch repeatedly to the point of
resistance in the direction of arrow : until
the panorama roof with power tilt/sliding
panel is fully closed.
X
Keep the 3 switch pulled for an additional
second.
X
Pull the 3 switch several times in the
direction of arrow : until the roller sunblinds
are closed.
X
Keep the 3 switch pulled for an additional
second.
X
Make sure that the panorama roof with power
tilt/sliding panel and the roller sunblinds can
be fully opened and closed again.
X
If this is not the case, repeat the steps above
again.
102
Sliding sunroof
Opening and closing