Instructions / Assembly

~
2
~
ELECTRIC LIFTING & RECLINING
First of all, check if local voltage is consistent with the transformer power supply，If
available，then plug in, to set up an electric circuit.
The top of the hand controller comes with a USB port to
facilitate charging of electronic products such as mobile phones.
Product require DC 29V Power，Boot indicator light up after electrify；
LIFT: Automatic lift function button. Just one click, the chair will lift up to top position；
RECLINE:Automatic recline function button. Just one click, the chair will recline to max unfold
position；
LIFT/RECLINE the 2 buttons can be changed at any time. For safety, when you click new button, the
last function will stop, and execute new function.
Up arrow button: should keep pressing to work, the chair will get down, then unfold to max
recliner position.
Down arrow button: should keep pressing to work, the back & footrest will revover, then lift up
to top position.
“Heat” key: Individual control switch，if users want the product to have the
spontaneous heat, they can press heating switch key for heating. The maximum heating value
is 65℃ and it takes about 15 minutes to reach the maximum heating value. There is a built-in
protective chip in the product, and the continuous heating will not make the heat value exceed
the maximum peak value.
Time” key: timing regulation key. Press “10-20-30” to regulate the time and the
corresponding mode indication lamp will be on.
Intensity” key: it has three-gear strength regulation key H-M-L. Press the key, the
strength indication lamp will flicker and the strength will change as per the sequence: M-L-H
cycling.
“Mode” key: it has three-mode switchover key. When the vibrating motor is in a start
state, the key can realize vibrating mode switchover,suchas M1→M2→M3→M1……and the
corresponding indication lamp will be on in certain mode.
Power On / Off，vibration massage power.
Operation Instructions










