User manual

Issue 02 Feb 92 Page 5 - 11
TS2000 (V2+) User Manual
STEP ACTION DISPLAY REMARKS
1 Eng Passcode* Press <YES> to
DEFINE CIRCUITS
Press YES to Define Circuits. Press NO to go to Define Outputs menu.
Use arrow keys to step through menus. Press 0 to quit
2 YES 001< CIRCUIT TYPE
* * * * *
Press YES to accept displayed circuit type, attribute and ward. Press
NO to change. Use arrow keys to step through circuits. Enter figures
to select new circuit
3 YES 002 < CIRCUIT TYPE
* * * * *
Previous display accepted as correct - new circuit displayed. Press
YES to accept displayed circuit type, attribute and ward. Press NO to
change. Use arrow keys or figures for new circuit
4 NO 002 > CIRCUIT TYPE
* * * * *
Change required.Press YES to accept this Circuit Type. Press NO or
arrow keys to change the circuit type then press YES to accept it
5 YES 002 CIRCUIT TYPE
>* * * * *
Press NO to change and YES to accept each Attribute. Press 0 to go
to step 7.
6 NO 002 CIRCUIT TYPE
>Rst * * * *
Attribute changed. Press Yes to accept then go to next Attribute. Press
0 to continue when all attributes are correct
7** 0 CCT 002 in Ward(s)
* * * * * * * *
Enter ward number to allocate circuit to a ward or to delete the ward if
already allocated. Press YES or 0 to return to step 3 when allocation is
complete
8** 3 CCT 002 in Ward(s)
* * 3 * * * * *
Circuit allocated to Ward 3. Press YES or 0 to return to step 3.
9 - - Continue as above until all the fitted circuits have been configured with
type, attribute and ward, if applicable, then at step 3 enter circuit
number 000
10 000 000< NOT VALID
<YES> to continue
Press YES or NO to go to step 1
11 YES Press <YES> to
DEFINE CIRCUITS
Press NO to go to Define Outputs menu. Press YES to repeat this
menu. Use arrow keys to step through menus. Press 0 to quit
* assumed starting point (may also be from menu 14)
** omit steps 7 and 8 if circuit cannot be allocated to a ward
5.14 Define Circuits (Menu 15)