User manual

Issue 02 Feb 92 Page 5 - 3
TS2000 (V2+) User Manual
STEP ACTION DISPLAY REMARKS
1 No* Press <YES> to
SELECT BELL TEST
Press YES to carry out Bell Test. Press NO to go to Omit/Enable
Circuits menu. Use arrow keys to step through menus. Press 0 to quit
2 YES Bell/Siren on
Press any key
Bell relay and programmed bell outputs will be activated until any key
is pressed
3 (YES) Strobe light on
Press any key
Strobe output and programmed strobe outputs will be activated until
any key is pressed
4 (YES) Local Sounder on
Press any key
Local sounders at all REM are activated until any key is pressed
5 (YES) Press YES to
SELECT BELL TEST
Press NO to go to Omit/Enable Circuits menu. Use arrow keys to step
through menus. Press YES to repeat this menu. Press 0 to quit
* from last step of previous menu
5.5 Select Bell Test (Menu 6)
STEP ACTION DISPLAY REMARKS
1 No* Press <YES> to
OMIT/ENABLE CIRCUITS
Press YES to Omit or Enable circuits. Press NO to go to Use Chime
Facility menu. Use arrow keys to step through menus. Press 0 to quit
2 YES CCT >001 Armed
Type or Text
First circuit with Attribute Omit displayed. Press YES to accept displayed
condition. Press NO to change it. Use arrow keys to step through circuits
3 YES CCT >002 Omitted
Type or Text
First circuit condition accepted. Press YES to accept new circuit displayed
condition. Press NO to change it. Use arrow keys to step through circuits
4 NO CCT 002 >Omitted
Type or Text
Circuit retained and condition to be changed. Press NO to change or YES
to accept
5 NO CCT 002 >Armed
Type or Text
Condition changed. Press YES to accept change. Press NO to change
again then YES to accept.
6 YES CCT >002 Armed
Type or text
New condition accepted. Continue steps 3 to 6 for other circuits or enter
000 to quit
7 000 CCT >000 NOT VALID
YES to continue
Press YES to return to step 1
8 YES Press YES to
OMIT/ENABLE CIRCUITS
Press NO to go to Use Chime Facility menu. Press YES to Omit or Enable
circuits. Use arrow keys to step through menus. Press 0 to quit
* from last step of previous menu
5.6 Omit/Enable Circuits (Menu 7)