User manual

Issue 02 Feb 92 Page 5 - 2
TS2000 (V2+) User Manual
STEP ACTION DISPLAY REMARKS
1 No* Press <YES> to
VIEW CIRCUITS
Press YES to View Circuits. Press NO to go to Event Log menu. Use
arrow keys to step through menus. Press 0 to quit
2 YES CCT >001 Healthy
TYPE/TEXT
Press YES to step to nexr circuit. Use arrow keys to step through
circuits. Enter figures to select new circuit. Press NO to return to step 1
3 YES CCT >002 Healthy
TYPE/TEXT
Press YES to step to nexr circuit. Use arrow keys to step through
circuits. Enter figures to select new circuit. Press NO to return to step
1. Enter 000 to exit
4 000 CCT >000 NOT VALID
YES to continue
Press YES to return to step 1
5 YES Press YES to
VIEW CIRCUITS
Press NO to go to next menu. Press YES to repeat this menu. Use
arrow keys to step through menus. Press 0 to quit.
* from last step of previous menu
5.2 View Circuits (Menu 3)
STEP ACTION DISPLAY REMARKS
1 No* Press <YES> to
VIEW EVENT LOG
Press YES to View Event Log. Press NO to go to Select Walk Test
menu. Use arrow keys to step through menus. Press 0 to quit
2 YES (last event)
(time date)
Most recent event displayed. Press YES to step through events. Press
NO to return to step 1
3 NO Press YES to
VIEW EVENT LOG
Press NO to go to Select Walk Test menu. Use arrow keys to step
through menus. Press YES to repeat this menu. Press 0 to quit
* from last event of previous menu
5.3 View Event Log (Menu 4)
STEP ACTION DISPLAY REMARKS
1 No* Press <YES> to
SELECT WALK TEST
Press YES to carry out Walk Test and go to step 4 if no Wards are
defined. Press NO to go to Bell Test menu. Use arrow keys to step
through menus. Press 0 to quit
2 YES Press YES to
WALK TEST SYSTEM
Only if Wards are defined. Press Yes to Walk Test system circuits.
Press NO if system circuits are not to be tested
3 YES WALK TEST WARDS ? :-
* * * * * * * *
Only if Wards are defined. Enter numbers of Wards to be tested.
Leave with no wards shown if no circuits in wards are to be tested.
Press YES to Walk Test ward circuits
4 YES Operate circuits
Any key to end
Operate circuits to test their functioning. Press any key to end test
5 (operate
circuit)
(Cct No.) Active
Type/Text
Circuit details are displayed and sounder beeps for about 2 seconds
as each circuit is activated. Press any key to end test
6 (YES) CIRCUITS ACTIVATED
in numerical order
Circuit details of each activated circuit displayed in sequence, and
program cycles until stopped, or None Activated is displayed. Press
YES/0 to return to step 1
7 YES Press YES to
SELECT WALK TEST
Press NO to go to Bell Test menu. Use arrow keys to step through
menus. Press YES to repeat this menu. Press 0 to quit
* from last step of previous menu
5.4 Select Walk Test (Menu 5)