User manual

Issue 02 Feb 92 Page 4-6
TS2000 (V2+) User Manual
4.11 Unset Wards with Circuits Omitted
STEP ACTION DISPLAY REMARKS
1 - SET- 1 (to) 8
(date) (time)
System has only the Wards indicated set. Enter passcode for access
2 Enter passcode Press YES to
START SET SEQUENCE
Press NO to unset wards. Press 0 to quit. (Press YES to set - see para
4.2)
3 NO Press YES to
UNSET WARDS
Press YES to unset wards. Press 0 to quit. (Press NO for Menu Mode)
4 YES UNSET WARDS? :-
1 (to) 8
Press YES to unset all the wards displayed. Enter numbers of wards
not to be unset - go to step 7. Press 0 to return to step 3. Pressing NO
has no effect
5 YES Wards Set . . . . . . . Momentary display
6A - SYSTEM UNSET
(date) (time) (OR)
System and all wards unset and omitted circuits re-instated
6B - CIRCUITS OMITTED
(date) (time)
Some circuits are still omitted. Enter passcode to proceed
7 Enter passcode Press YES to
START SET SEQUENCE
Press 7 to enable omitted circuits - go to Omit Circuits Para 5.6 steps 1
to 7. (Press YES to set system and wards)
8 YES Press YES to
OMIT/ENABLE CIRCUITS
End of the Omit/Enable sequence. Press 0 to quit
9 0 SYSTEM UNSET
(date) (time)
System and all wards unset and omitted circuits re-instated
4.12 Omit Circuits
STEP ACTION DISPLAY REMARKS
1 - CCT >023 Armed
Type or Text
Omit sequence entry point. First circuit with Attribute Omit which is not
at present omitted. Press YES to go to next circuit. Enter numbers to
select another circuit. Press NO to change this display
2 YES CCT >035 Omitted
Type or Text
The first circuit with its displayed condition was accepted and the next
circuit is now displayed. Enter numbers to display another circuit.
Press NO to change circuit condition
3 NO CCT 035 >Omitted
Type or Text
Circuit retained. Press NO to change condition or YES to accept it
4 NO CCT 035 >Armed
Type or Text
Condition changed. Press YES to accept this condition or NO to
change again
5 YES CCT >035 Omitted
Type or Text
Condition accepted. Continue steps 2 to 5 or enter 000 to quit
6 000 CCT>000 NOT VALID
YES to continue
Press YES to quit
7 YES (return point) Program returns to start point