User manual

The omitted circuits will be automatically enabled when the system or relevant ward is unset
unless the ward is key controlled.
3.11 Use Chime Facility (Menu 8)
Night circuits can be programmed to Chime when activated and the panel is Unset and this is
done by:
(1) Selecting the circuits which are to chime when active;
(2) Selecting whether the system and or ward circuits are to chime and the ward
numbers if wards are selected;
Having selected which circuits can chime, then selected Wards of circuits or the System
circuits may be enabled or disabled to chime.
3.12 Use the Printer (Menu 9)
System information and a number of logs are held by the system and these may be printed if
required as follows:
(1) Print All - all programmed information;
(2) Print Circuits - all Circuit configurations;
(3) Print Outputs - all Output configurations;
(4) Print Timers - all Timer settings;
(5) Print System Modes - All system mode settings;
(6) Print Ward Alarms - all ward alarms;
(7) Print Users - list of Users;
(8) Print Dictionary - all the dictionary text;
(9) Print DC3 data - all the DC3 or DC3M programmed data;
(10) Print Event Log - all the events logged;
(11) Cancel Printing - stop the printing sequence.
3.13 Alter Clock (Menu 10)
The system calender and clock may be changed with this facility. To obtain an accurate time
set the clock in advance and press the final Yes (for seconds) at the correct time.
3.14 Alter Passcode (Menu 11)
This facility is for the Engineer and for any User except the Master so that they can enter a
new passcode for themselves. When entering a Passcode it must be entered twice for
verification purposes and the correct number of digits (4 or 6) must be entered. If a number is
selected that is in use by another User it will not be accepted.
3.15 Define Users (Menu 12)
There are 50 Passcode slots available and each may be allocated one of the Passcode Level
names (para 2.3) and a Passcode number. This menu allows the Master User to:
(1) Allocate the slots to a level of User ;
(2) Allocate passcodes to the Users including himself;
(3) Delete a User;
(4) Allocate which Wards may be Unset by which User;
(5) Allocate which Wards may be Set by which User;
3.16 Alter Time Switch (Menu 13)
A Time Switch function, which may be used to provide a pre-selected timed output, may be
programmed with two On times and two Off times, designated Time 1 and Time 2, and each
may be allocated to operate on any number of days of the week. The time switches may be
Issue 02 Feb 92
TS2000 (V2+) User Manual
Page 3 - 3