User's Manual

Command Dictionary Report Test Stimulus
FastScan and FlexTest Reference Manual, V8.6_4
2-381
specify multiple argument pairs with a single -Set switch. The following
describes the possible switch arguments and literals:
id# — An integer that specifies the gate identification number of the gate
whose output pin you want to set. The gate may not be a RAM or ROM
gate.
pin_pathname — A string that specifies the pathname of the pin that you
want to set.
0 — A literal that sets the id# or pin_pathname to 0.
1 — A literal that sets the id# or pin_pathname to 1.
Z — A literal that sets the id# or pin_pathname to Z.
• -Write id# | instance_name address_values data_values
A switch with a repeatable argument that specifies the RAM to which you
want to write and, optionally, its address and data values. You may specify
multiple argument triplets with a single -Write switch. The following describes
the possible switch arguments:
id# — An integer that specifies the gate identification number of the RAM
gate to which you want to write.
instance_name — A string that specifies the pathname of the RAM
instance to which you want to write.
address_values — A required character string consisting of 0’s and 1’s that
specifies the values you want to place on the RAM address lines. The least
significant value must be the last character in the string. The number of
characters in the string must not exceed the number of RAM address lines
available.
data_values — An optional character string consisting of 0’s, 1’s, and X’s
that specifies the values you want to place on the RAM data lines. The least
significant value must be the last character in the string. The number of
characters in the string must not exceed the number of RAM data lines
available.
If you do not specify the -Port switch, the command assumes the first port (port
0).