User Manual

Troubleshooting

If a fault is found, an indicator will start to blink intensively.

Indicators

Trim tabs not found in

calibration

L1 R1 Wrong installation angle

Short-circuit to the

positive side

Short-circuit to

ground

Trim tabs not found

at start up

Supply voltage

During a fraction of a second, when starting a trim tab motor, the current is much higher than normal

and the supply wires, fuseholder and battery should be in a good condition. This is important when

replacing mechanical switches with electronic equipment. Check the voltage supply by manually

operating the trim tabs. If the supply is weak, the ACS will restart and flash all the indicators twice.

Warranty policy

All ACSs (Attitude Control Systems) purchased through authorized distribution channels are guaranteed

against defects of material or workmanship for a period of 24 months from date of purchase. Service

will be rendered, and defective parts will be replaced without cost to you within that period, provided

that the equipment does not show any evidence of an impact, liquid damage, mishandling, tampering,

or chemical corrosion, operation contrary to operating instructions, or modification by an unauthorized

repair shop. Any ACS that proves defective during the 24-month warranty period should be returned to

the dealer from whom you purchased the equipment or to the manufacturer. If the equipment is

covered by warranty, repairs will be made and parts replaced free of charge, and the equipment will be

returned to you upon completion of servicing. Shipping charges are to be borne by the owner. To prove

the date of purchase when required, please keep the receipts or bills covering the purchase of your

equipment for at least two years.