User Manual

13
Adjusting gain
The gain determines how fast the ACS should correct a list condition. It can be adjusted in three steps
and the default setting is step II. Step I provides a little slower correction, while step III is the fastest.
The setting is optimized, if a list condition is corrected without the boat leaning over to the other side
and the trim tabs are not operated too often.
Press the
left and right button
simultaneously for 4 seconds until an
indicator in the middle starts to blink.
Adjust the gain setting with the uppermost
and lowermost buttons. The three indicator
LED’s in the middle show the setting.
Then, press the left and right buttons again
for 4 seconds to store the setting.
Specifications
Compliance
(Hydraulic tabs)
Bennett, Instatrim, Trimmaster, TFX Teleflex, TX Controls
Compliance
(Electromechanical tabs)
Lectrotab, Lenco, Eltrim, Ultraflex, Minn Kota
ACS R Control in the roll axis
ACS RP Control in the roll and pitch axes
Boat length 15...40 feet
Tab type detection Automatic
Gain Automatic, adapts to the boat type
Size 80 * 77.5 * 10 mm
Protection by enclosure IP 68
Operating temperature -10...85

C
Storage temperature -40...+85

C
Supply voltage 10...30 V dc
Maximum output current 18 A (When tabs activated)
Current consumption 0.02 A (When idle)
Approvals CE (Compliance with EMC regulations)
The CE marking assures that this product
complies with the requirements of the EC
directive for electromagnetic compatibility.