User Manual

12
Usage
Attitude setting
Run the boat at cruising speed. Manually
control the trim tabs until you find the best
attitude. Then, press and hold the auto
button for 4 s until the AUTO indicator is lit
up.
Now, the attitude is stored in the memory,
and the ACS is set in the automatic mode.
Fine adjustment
In the automatic mode, press any of the four
buttons to alter the setting 0.5 degrees in a
certain direction. Press more times for a
greater change.
Press and hold the auto button for 4 s to
store the new setting in memory.
Now, if the speed is reduced, automatic control is suspended and the AUTO indicator starts to blink. The
functionality is then temporarily interrupted to avoid deflecting the tabs at too low a speed.
The automatic mode is re-entered every time you go out, until the ACS is put into manual mode. By
pressing the AUTO button, you can toggle between the automatic and manual mode. The running
attitude remains in the memory, although the main breakers are switched off.
Retraction
Retraction prevents fouling of the actuators. ACS automatically retracts the trim tabs when the boat has
been off the plane for a while. If terminal 7 has been connected to the ignition, ACS will not retract the
trim tabs until the engine is switched off.
Shut down
When not in use for a while, ACS shuts down, drawing minimal current from the battery. This feature
prevents battery drain and the boat may be left for months with the main breakers on. The ACS will be
activated again when there is a need to adjust the trim tabs.