Specifications

12 | Page
PLANNING THE INSTALLATION
When planning on appliance installation, it is necessary to determine the following information before installing:
Where the appliance is to be installed.
The vent system configuration to be used.
Gas supply piping.
Electrical Wiring.
Framing and finishing details.
Hearth Protection Pad Requirements.
Whether accessories such as a wall switch, remote control, and ceiling fan are desired.
Selecting Appliance Location
When selecting a location for your appliance, it is important to consider the required clearances to walls. See Error! Ref-
erence source not found. and Figure 2: Clearances to Combustibles.
Figure 3: Planning Installation
WARNING
FIRE RISK- ODOR RISK
Install appliance on hard metal or wood surfaces extending full width and depth of this fireplace.
An R-1 Rated Hearth Protection Pad [1-´7KLFN0D[LPXP@LVUHTXLUHGXQOHVVWKLVILUHSODFHLVHOHYDWHG
)RUHYHU\´WKLVILUHSODFHLVHOHYDWHG\RXPD\UHGXFHWKHKHDUWKSDGGHSWKE\´,IWKLVILUHSODFHLVHOe-
YDWHG´RUKLJKHUQRKearth protection pad is required.
Do NOT install this fireplace directly on carpeting, vinyl or any combustible material other than wood. Con-
struct chase to all clearance specifications in manual.
Locate and install appliance to all clearance specifications in manual.
70
3
4
"
51
3
8
"
18"
17
3
4
"
25
1
4
"
19
1
2
"
In addition to these dimensions, also reference:
Mantel Clearances Section
Framing Dimensions Section
Venting Configuration Section
19-1/2"
MIN.
35
3
8
"
42-1/2" MIN.
42-1/2 MIN.
ROUGH FRAMING
WIDTH
42-1/2 MIN.
ROUGH
FRAMING WIDTH