Owner`s manual

REMOTE CONTROL UPGRAGE KIT -DXV35 DT3
INSTALLATION INSTRUCTIONS
Page 9 of
32
FRONT
OUTLET
AUX
FCM
LIGHT DIMMER
ACCENT
LIGHT PLUG
REAR
OUTLET
WIRING CONNECTIONS
Follow all wiring instructions in the exact order given here. Failure to follow in order will lead to improper wiring
which can lead to damage to the gas valve, rear burner solenoid, fan control module, fan rheostat and remote
receiver. Damage due to improper wiring is not covered under the Mendota Warranty Policy.
Follow each step, below, exactly and in the exact order given. Make certain that the Courtesy Panel is removed
and rotated downward to provide access inside the fireplace cavity.
STEP 1: ACCENT LIGHT SYSTEM PLUG HARNESS REMOVAL
Locate Accent Light Harness Plug. Trace the wires from the Accent Light Dimmer to the Plug. This plug is factory
assembled and plugged in to the “FRONT” outlet on the Right Side of the Fireplace.
Unplug the Accent Light Harness from where it is plugged in and pull out towards the front of the unit.
WARNING: DO NOT REMOVE THE OTHER PLUG THAT IS CONNECTED TO THE REAR OUTLET!
STEP 2: FAN CONTROL MODULE INSTALLATION (item #1)
Unwrap and extend the plug harness connected to the Fan Control Module (FCM).
Insert FCM plug inside unit on right side and plug this harness into the same outlet you removed the Accent Light Plug
from.
Plug the Accent Light Plug into the AUX OUT outlet on the Fan Control Module.
TO
ACCENT
LIGHT