Owner`s manual

REMOTE CONTROL UPGRAGE KIT -DXV35 DT3
INSTALLATION INSTRUCTIONS
Page 8 of
32
BATTERY PACK REMOVAL AND RECEIVER INSTALLATION (item #2)
Locate Battery Pack and Battery Pack Bracket. Disconnect Wires from Battery Pack and remove Battery Pack
and Battery Pack Bracket. Discard Battery Pack and Battery Pack Bracket.
NOTE: Red and Black Wires connected to Battery will not be used with the Remote Kit. Leave wires intact inside
fireplace but not connected to any other wire harnesses.
Install Receiver. Receiver mounts using the same screws that secured Battery Pack Bracket to Courtesy Panel.
Reuse these screws to
mount Receiver.
NOTE: Battery Compartment
cover with “ON-REMOTE-OFF”
decal shall be on TOP.