Owner`s manual

REMOTE CONTROL UPGRAGE KIT -DXV35 DT3
INSTALLATION INSTRUCTIONS
Page 6 of
32
INTRODUCTION
WARNING
: THIS KIT MUST BE INSTALLED BY AN AUTHORIZED AND TRAINED GAS FIREPLACE INSTALLER OR
SERVICE PERSON. INSTALLATION BY A “HOME OWNER” IS PROHIBITED! THIS KIT IS DESIGNED FOR
INSTALLATION ON DXV35 DT3 MODEL UNITS ONLY. THIS KIT IS NOT COMPATIBLE WITH OLDER GENERATION
DXV35, DXV35TF, DXV35DT1 OR DXV35DT2 MODELS.
GENERAL INFORMATION
This MENDOTA BurnGreen Remote Control upgrade kit adds remote control functionality to all features of the DXV35
DT3 Fireplace. This includes Manual, Thermostatic and Smart Thermostat functions, IPI pilot flame ignition and main
burner ignition functions, Flame Height modulation function, Rear Burner On/Off function, Accent Light On/Off function
and Blower speed regulation function.
NOTE: This Remote Kit Will Not Turn The Blower System To Off If The Fireplace Is Hot. The Blower Will Turn Off Only If
The Fireplace Has Cooled Down Close To Room Temperature. This is a feature installed to transfer ALL heat contained
in the Fireplace Body to the living space rather than letting the heat expel out through the exhaust system.
BEFORE YOU BEGIN
CAUTION:
MAKE CERTAIN THE PILOT LIGHT IS TURNED OFF AND DISCONNECT THE ELECTRICITY SUPPLY TO
THIS FIREPLACE BEFORE STARTING THIS UPGRADE PROCESS.
Open glass door and remove glass frame and set aside.
Remove two screws that secure courtesy panel to Valve Assembly then slowly pull Courtesy Panel our of Unit
and rotate down to expose rear surface of Courtesy Panel. DO NOT PUT TENSION ON WIRE HARNESSES!