Owner`s manual

REMOTE CONTROL UPGRAGE KIT -DXV35 DT3
INSTALLATION INSTRUCTIONS
Page 3 of
32
REMOTE CONTROL UPGRADE KIT FEATURES - QUICK REFERENCE INFORMATION
PILOT IGNITION CONTROL: IPI Electronic Ignition of Pilot Flame and main burners from Remote Control.
Rear burner On/Off: Rear Burner On/OFF function from Remote Control.
Flame Height Control: Flame height and heat output can be regulated from Remote Control.
Blower On/Off and Speed Control: Remote Control can initiate blower On when fireplace is cold. Once unit warms up,
Remote Control can regulate blower speeds in six steps. However, if Fireplace has warmed up, blowers will stay ON
regardless of the remote control sending an OFF signal to Fireplace. In these instances, blowers will run at the preset
LOW speed to extract all heat from fireplace. Blowers will turn OFF when unit cools down sufficiently.
NOTE: RHEOSTAT MOUNTED IN COURTESY PANEL TO CONTROL BLOWER SPEED MUST BE ADJUSTED TO
THE LOWEST BLOWER SPEED LEVEL IF THIS REMOTE CONTROL KIT IS INSTALLED.
Accent Light On/OFF Control: Accent Light can be turned ON or OFF from remote control. Accent Light Dimming
cannot be done from Remote Control. An additional Accent Light Dimmer mounted in Fireplace’s Courtesy Panel must be
ON for accent light to function. Accent Light Dimmer mounted in Fireplace control Accent Light Intensity.