Owner`s manual

REMOTE CONTROL UPGRAGE KIT -DXV35 DT3
INSTALLATION INSTRUCTIONS
Page 24 of
32
3
6
4
3
6
4
MANUAL
LP Pressure
Regulator
[10.0-6.4"WC]
# 0.907.011
Burner Orifice
#65-14-00364
[3/64"DRILL]
LP Pilot Orifice
[#05-04-00052]
[#977.168]
NATURAL TO LP GAS CONVERSION INSTRUCTIONS
Kit # HA-30-00501 Mendota Model DXV35 DT3
This conversion kit shall be installed by a qualified service agency
in accordance with the manufacturer’s instructions and all
applicable codes and requirements of the authority having
jurisdiction. If the information in these instructions is not followed
exactly, a fire, explosion or production of carbon monoxide may
result causing property damage, personal injury or loss of life. The
qualified service agency is responsible for the proper installation of
this kit. The installation is not proper and complete until the
operation of the converted appliance is checked as specified in the
owner instructions supplied with the kit.
Caution: The electrical supply to the fireplace must be turned off
prior to performing the conversion. The gas supply must be shut
off prior to disconnecting the electrical power.
ORIFICE SIZES REQUIREMENT:
A Natural Gas to LPG conversion kit #HA-30-00501 is included
with this fireplace insert.
LP Conversion Kit # HA-30-00501 contains the following parts: One Motorized LP Pressure Regulator #907.012, One LP
Pilot Orifice Thimble #977.168, and two Cap Orifices #65-14-00364(drill #3/64”) and an L-shaped Torx wrench.
RECOMMENDED PROCEDURE TO CONVERT THIS FIREPLACE TO BURN LPG
This Fireplace Insert arrives from the factory ready to burn Natural Gas. If you intend to burn LPG, it is highly
recommended that you convert this fireplace and its Pressure Regulator, Pilot Orifice Thimble and Burner Orifices prior to
placing this fireplace in its fireplace cavity.
See diagrams, on this page, and follow these instructions to prepare this fireplace for conversion to LPG.
Using a ¼” Hex Driver, remove 2 screws that secure the Rear and Front burners to the Burner Airbox.
Lift Up and remove Front Burner.
Loosen Front Burner Air Shutter Screw and rotate air shutter open ¼” minimum. Set burner aside.
Slide Rear Burner to the right about 2” and lift up and remove from Firebox.
BURNERS MOUNTING
SCREWS
FRONT BURNER
REAR BURNER