Owner`s manual

REMOTE CONTROL UPGRAGE KIT -DXV35 DT3
INSTALLATION INSTRUCTIONS
Page 22 of
32
control feature of the system and the appliance’s main burner will turn on. The fan will run at its maximum speed and the
Accent Light may turn on.
To turn off the appliance, if the remote control is misplaced or lost, slide the three position slider switch on the wall
receiver to the OFF Position.
TEMPERATURE INDICATOR (
o
F or
o
C)
1. Press the ON/OFF Key and Turn Off the Fireplace.
2. Simultaneously, Press both the MODE Key and the Thermostat
Key.
3. Look at the LCD display to verify that your desired indicator (
o
F or
o
C) is being displayed. If not, repeat step 2.
KEY LOCK FUNCTION
To prevent unsupervised children from operating the fireplace, a KEY LOCK function is
provided with this remote control system. To activate the KEY LOCK function,
simultaneously press the “MODE KEY” and the “UP KEY”. To deactivate the KEY LOCK
function, simultaneously press the “MODE KEY” and the “UP KEY”.
During KEY LOCK mode, none of the Keys will function. You must DEACTIVATE the
system before you can use the Remote Transmitter.
LOW BATTERY POWER DETECTION
1. Transmitter Batteries: The life span of the remote control transmitter batteries depends
on various factors: quality of the batteries used, the number of ignitions of the appliance,
the number of changes to the room thermostat set point, etc. When the Transmitter
batteries are low, a Battery Icon will appear on the LCD display of the Transmitter before
all battery power is lost. When the batteries are replaced, this icon will disappear.
2. Receiver Batteries: The life span of the receiver batteries depend on the quality of the
batteries used and how long the batteries have been installed in the receiver. These batteries are only utilized during
power outages. Replace these batteries every heating season even if you have not experienced any power outages.
Batteries drain slowly even when not in use. This is a normal characteristic of all batteries.