Owner`s manual

REMOTE CONTROL UPGRAGE KIT -DXV35 DT3
INSTALLATION INSTRUCTIONS
Page 19 of
32
Connections of all new wire connector ends are now complete. Double check all connections and confirm that all
connections are secure and that wires are routed properly so no wires will be pinched when replacing the Courtesy Panel.
DO NOT REPLACE THE GLASS FRAME AT THIS TIME.
TESTING THE MAIN WIRING SYSTEM
1. Turn ON the electricity to Fireplace.
2. Turn ON the gas supply to Fireplace.
3. Toggle PILOT LIGHT ON/OFF SWITCH to “Standing Pilot” position. You should hear and visibly see sparking at
the pilot light. After the air in the gas line has bled through, the pilot light will ignite and remain lit.
4. Slide Remote Receiver Slider Switch to ON. Burners should ignite. Slide Remote Receiver Slider Switch to
“REMOTE” position once burners ignite. DO NOT LEAVE BURNERS ON FOR MORE THAN 30 SECONDS.
5. Install Glass Frame on Fireplace and secure with two spring latched located on top of firebox.
6. Insert “AAA” Batteries in Remote Transmitter.
7. Press “PRG” button on Remote Receiver. You will hear a “beep”.
8. Press any button on the Remote Transmitter. You will hear “beep, beep, beep” indicating that the remote
transmitter and remote receiver are synchronized.
9. Test Blower Functions and Accent Light Functions in “MANUAL THERMOSTAT MODE”. See REMOTE
TRANSMITTER OPERATING INSTRUCTIONS section of this manual.
Once you have verified that all functions operate properly, reinstall Courtesy Panel carefully. Make certain no wires or
connectors are pinched between metal parts.