Owner`s manual

REMOTE CONTROL UPGRAGE KIT -DXV35 DT3
INSTALLATION INSTRUCTIONS
Page 18 of
32
DFC-SUPPLY
v. Connection to the DC-Supply connector
See diagram, below, that identifies the connectors on
the left side of the Courtesy panel’s back-side..
Identify the “DC- SUPPLY” CONNECTOR from which
you disconnected the AC/DC Transformer. Identify the
matching connector that is part of the “Receiver
Harness”. Connect the Male AC/DC adapter to the
connector labeled “DC-SUPPLY”.
vi. Connection to the Green colored TH terminal and the White Colored TPTH terminal (TPTH and TH)
Locate the ON/OFF Switch on the left side of Courtesy Panel. Identify the short jumper wires that are connected to the
switch. Identify the Green and White colored wires with label “ON-OFF” that connect to these two short jumper wires.
Disconnect the White and Green wires connected to the short jumper wires. Identify the Green Wire (part of the Receiver
Harness) labeled “TH”. Connect this wire to the Green wire labeled “ON-OFF”. Identify the White Wire (part of the
Receiver Harness) labeled “TPTH”. Connect this wire to the White wire labeled “ON-OFF”.
ON-OFF
TPTH
TH
1. DISCONNECT “ON-OFF” WIRES FROM
ON/OFF SWITCH WIRE JUMPERS.
2. CONNECT “TH” WIRE TO GREEN “ON-
OFF” WIRE
3. CONNECT “TPTH” WIRE TO WHITE
“ON-OFF” WIRE.
WARNING – GREEN WIRE (TH) MUST
MATE WITH GREEN WIRE IN ON-OFF
CIRCUIT. WHITE WIRE (TPTH) MUST
MATE WITHWHITE WIRE IN ON-OFF
CIRCUIT. IF YOU MISMATCH COLORS,
YOUR SYSTEM WILL NOT FUNCTION!