Owner`s manual

REMOTE CONTROL UPGRAGE KIT -DXV35 DT3
INSTALLATION INSTRUCTIONS
Page 17 of
32
SPLITFLOW
iii. CONNECTION TO THE MOTORIZED PRESSURE REGULATOR (STEPPER MOTOR)
Locate the ribbon cable connected to the Motorized Pressure Regulator. The connector at the end of this cable connects
to the connector labeled “MOTOR” that is part of the Receiver Harness. The connectors can mate only one way. Do not
force.
iv. Connection to the Rear Burner Solenoid Valve (Split Flow)
Locate the loose connector at the end of the Pink and Blue wires that are attached to the Rear Burner Solenoid Valve
(Split Flow). Locate the connector labeled “SPLIT FLOW” in the Receiver Harness. Attach these two connectors together.
Make certain pins in the male connector are not bent before connecting to the female connector.
MOTOR
CONNECTORS
(SPLIT FLOW) REAR
BURNER SOLENOID
CONNECTORS
STEPPER