Owner`s manual

REMOTE CONTROL UPGRAGE KIT -DXV35 DT3
INSTALLATION INSTRUCTIONS
Page 16 of
32
i. CONNECTION TO REMOTE CONTROL RECEIVER
Connect the white multi-wire connector labeled “RECEIVER” to the port in the rear of the Remote Receiver. Note that the
connectors are keyed so insertion is only allowed if the connectors are oriented correctly. Do not force. If connectors are
aligned properly, they will engage easily. See diagram, below.
ii. CONNECTION TO THE FAN CONTROL MODULE (FCM)
Locate the COM port in the FCM. Locate the small white connector labeled “FCM-COM”. Note that the connectors are
keyed so insertion is only allowed if the connectors are oriented correctly. Do not force. If connectors are aligned properly,
they will engage easily.
RECEIVER
FCM-COM