Operating instructions

ManualsBrandsMendota ManualsLawn and GardenDXV-35 DEEP TIMBER II

HEARTH PAD SURFACE MUST BE

FLUSH WITH FIREPLACE BOTTOM

IF INSTALLING THE

WELLINGTON!!

HEARTH PAD

SURFACE

Information specific to the installation of Millennia Flat Grills, Victoria Filigrees and Tuscany Filigrees

The Millennia Flat Grills, Victoria Filigree and Tuscany Fili-

gree are designed to be “inside-fit” trim kits. All of these trim

kits fit within the inner perimeter of the Fireplace’s Faceplate

and remain flush within the Faceplate’s front surface, see Fig-

ure below. This fitting method allows flexibility in covering

the black visible surface of the Faceplate with non-combustible

materials such as Tile, Marble, Slate, Stone and Brick; as long

as enough room is allowed for the removal of these Mendota

Designer Fronts and the glass door for servicing,

WARNING: COMBUSTIBLE MATERIALS

MUST NOT COVER THE FRONT SURFACE

OF THE FIREPLACE’S FACEPLATE.

Figure 18

Information specific to the installation of the

WELLINGTON FIRESCREEN FRONT:

The Wellington Fire screen Front is designed to be “in-

side-fit” trim. The top and sides of these trim kits fit with-

in the inner perimeter of the Fireplace’s Faceplate. The

bottom member of this trim, however, overlaps the bottom

2” black boarder of the fireplace front faceplate. There-

fore, DO NOT COVER THE BOTTOM 2” BOARDER

OF THE FIREPLACE FACEPLATE WHEN

INSTALLING THE WELLINGTON FIRESCREEN

TRIM. The sides and top edges of the black visible sur-

face of the Faceplate may be covered with non-

combustible materials such as Tile, Marble, Slate, Stone

and Brick; as long as enough room is allowed for the re-

moval of this Mendota Designer Fronts

and the glass door for servicing,

Hearth Protection Pad Installation Information

when planning to install the Wellington Front

If planning to install the Wellington Front, the hearth pro-

tection pad installed in front of the DXV-35 Fireplace must be designed,

built and installed so that the hearth protection pad’s top surface is flush

with the bottom-most surface of the DXV35 Fireplace. See FIGURE 21.

Figure 20

DO NOT COVER THIS AREA OF THE FACEPLATE WHEN

INSTALLING THE WELLINGTON FIRESCREEN FRONT

ONLY THE CROSS HATCHED AREA MAY BE COVERED

WITH NON-COMBUSTIBLE MATERIALS WHEN INSTALLING

THE WELLINGTON FIRESCREEN FRONT.

ure 19