Operating instructions

25
GLASS FRAME ASSEMBLY REPAIR AND REPLACEMENT
TO REPLACE DAMAGED GLASS
Using an 1/8” drill bit, drill through 3 rivets on each side of glass frame.
Remove glass retainer brackets and the damaged glass and gasket material. Clean the inner surface of the glass frame.
Assemble new gasket on glass edge starting with the bottom left corner. The adhesive on the gasket should make contact
with the glass surface. Use tracer lines in gasket to determine where the glass should sit on the gasket surface.
Place glass and gasket assembly in glass frame. Carefully attach glass retainer brackets to sides of glass frame using
new 1/8” Aluminum rivets.
The glass frame assembly and its individual components are available through Johnson Gas Appliance Company. Contact
your dealer for more detailed ordering information.
GLASS FRAME ASSEMBLY REPLACEMENT PARTS LIST
ITEM PART NUMBER DESCRIPTION
1 HA-41-00313 GLASS FRAME, DXV45
2 65-02-00103
GASKET, TADPOLE,
3/8”BULB, 3/4” TAIL
3 65-06-00658 GLASS, CERAMIC, DXV45
WARNING
Do not operate this appliance
with the glass removed,
cracked or broken. Glass
should be replaced by a li-
censed or qualified person.
WARNING
Use only authorized parts and
materials obtained from Johnson
Gas Appliance Company when
replacing defective or damaged
glass.
DO NOT substitute other manufac-
turer's materials or components.
DO NOT operate unit with cracked,
broken or missing glass.
DO NOT abuse the glass door by
striking the glass, slamming the
door shut, etc
GLASS
TRACER LINES
IN GASKET
GLASS SHALL SIT BETWEEN
TRACER LINES IN GASKET
ROTATE GASKET UP
SO ADHESIVE MAKES
CONTACT WITH GLASS
SURFACE
ADHESIVE
GASKET
GASKET IN
FLAT FORM