Installation Instructions

Now, measure 2” in from the corners and screw in the four
top plates where the legs will attach to with the provided
screws. After this is complete, screw the legs into place.
STEP 10: Attach Leg top plates
Set the bottom into place and drill pilot holes with a
countersink bit. Screw the bottom into place with 1” wood
screws with four screws along each edge.
STEP 9: Attach Bottom piece
Attach the center divider of the coffee table (as seen
here). Make sure the front of the divider is 14 inches
from the side. Next, place a dab of glue on a pocket
hole plug and insert it into the pocket hole, then do this
for all pocket holes. Let the glue dry before sanding the
plugs so that they are as smooth as the surface of the
plywood.
STEP 8: Attach center divider
Now glue and screw the back piece to one side and to the
table top as seen here.
STEP 7: Attach back piece
Next, place the coffee table top on a workbench with
the bottom side facing up. Deposit a bead of wood glue
along the edge and clamp one of the side pieces to it
so that the pocket holes are next to the table top.
Screw the sides to the top (as seen here) using pocket
screws. Do this for both ends of the coffee table top.
STEP 6: attach sides