Installation Instructions

For the 14” coffee table back section, drill three pocket
holes along one edge and one on each side as seen here.
This will make attaching the back easier during nal
assembly.
STEP 5: Drill Back pocket holes
Set up your pocket hole jig according to the manufacturer’s
instructions before drilling four pocket holes in each of the
sides and center divider. The holes should be spaced to be
about six to eight inches apart.
STEP 4: Drill pocket side holes
From your remaining piece of plywood, measure and
cut ve 23-3/4” x 6-1/2” sections; these will form the
sides and a center divider. Then cut one 14” x 6-1/2”
section for the back of the coffee table. After you have
made all of your cuts, sand all of the edges and
surfaces smooth.
STEP 3: Cut remaining Pieces
Measure and cut two 23-3/4” x 23-3/4” pieces; these will
form the top and bottom of the end table.
STEP 2: Cut end table top and bottom
From your 4’ x 8’ sheet of plywood, measure and cut
two 48” x 23-3/4” sections; these will be the top and
bottom of the coffee table.
STEP 1: Cut Coffee Table Top & Bottom