Installation Instructions

Measure and cut a 50" long piece from one end of the
1/2" x 2' x 8' plywood panel. Measure and cut this 50"
long piece into two 10” wide by 50” long sections;
these will form the two sides.
STEP 1: cut side sections
For the front and bottom pieces, cut two 10" wide pieces
from the remaining section of the 1/2" piece of plywood.
STEP 2: cut sections
From the 10" wide sections, measure and cut ve 7-1/16” x
10” wide sections, then measure and cut six 4-5/8” x 10” wide
sections. These will form the fronts and bottoms of the
organizer.
STEP 3: cut front and bottom sections
Mark 5" x 5" squares on both of the side section pieces.
Draw an alternating diagonal line through each square to
mark the areas that need to be cut. Clamp the piece down
and carefully cut the diagonal sections with a jigsaw. You
should now have two side pieces with zigzag edges.
STEP 4: Mark and cut side sections
Measure and cut an 11" x 50" piece from the 1/4" x 2' x 8'
plywood piece. This will form the back section of the
organizer.
STEP 5: cut back section