Assembly Instructions

Clamp and screw in the eight 11-1/4" boards around
the frame using 1-1/4" screws.
Take the second frame (the rectangle with the gap on one
side) and insert it within the 11-1/4" boards. Make sure it is
2" apart all the way around so the guide lines match up
correctly with the 11-1/4" boards. Then, securely clamp
down the second frame for drilling.
STEP 18: Clamp Second Frame
Attach the second frame using the 1-1/4" screws.
STEP 20: Attach the Second Frame
Measure the bottom of the frame across the length and
width. This should result in a measurement of 43-1/2"
across the width and 33-1/2" across the length.
STEP 21: Measure Frame
Drill two pilot holes on each 11-1/4" board so that they
align with the top rectangle. Drill the pilot holes using the
1/8" drill bit.
STEP 19: Drill Pilot Holes
STEP 17: Clamp & Screw