Assembly Instructions

Take the two 10" boards and place them on the 32" board
ends of the second frame so that the ends are ush.
Drill two pilot holes through both 10" boards. The pilot holes
should be 1-1/2" vertically apart from each other where the
boards meet with the 32" board ends.
STEP 13: Drill Pilot Holes
Measure and mark all eight of the 11-1/4" boards at 2",
5-1/2", 7-1/2", and 11" to be used as guidelines when
clamping the two frames together. Use a speed square to
mark lines where indicated.
STEP 15: Measure and Mark 11-1/4"
Using the pilot holes made in the previous step, screw on
the two 10" boards with 2-1/4" screws. The second frame
should now be a rectangle, but with a gap of 23-1/2" in
between the two 10" boards.
STEP 14: Attach 10" Boards
STEP 12: Lay Out 10" Boards
Measure 3-1/2" out from each corner of both frames for a
guide to place the 11-1/4" boards. Place the boards on the
back, sides, and front so that they are 1/4" longer than the
bottom (they will stick up 2" from the top). Make sure there
is a 2" gap between the two frames.
STEP 16: Measure & Mark Frame